Electrolux Canister vacuum Parts — Browse All Models

How to replace the suction motor in your Electrolux canister vacuum

• Unplug the power cord to disconnect the electrical supply to the vacuum.
• Pull the release tab on the exhaust filter cover and lift the exhaust filter cover off the vacuum cleaner. Remove the exhaust filter from the housing.
• Pull the plastic release tab on the front of the canister and lift the canopy hood. Remove the hood from the canister.
• Remove the screws that secure the motor cover and remove the cover.
• With the wires still attached, carefully lift the suction motor out of the canister. Remove the foam padding that surrounds the motor. Note the location of the wires and then disconnect them. Remove the motor and set aside for disposal.
• Connect the wires to the new motor. Wrap the foam padding around the motor and then slide the motor into the canister.
• Reinstall the motor cover, insert the screws and tighten firmly. Snap the hood into place on the canister. Reinstall the exhaust filter in the housing at the back of the canister. Snap the exhaust filter cover into place.

Top-selling parts for Electrolux canister vacuum cleaners

• HEPA filter. The HEPA filter traps dust, pet dander and pollen from exhaust air in the vacuum cleaner.
• Vacuum dust bag. The vacuum dust bag collects the dust and dirt that the vacuum cleaner sucks up.
• Brush roll drive belt. The brush roll drive belt transfers motion between the drive motor pulley and the brush roll.
• Dirt sensor control board. The dirt sensor control board receives signals from the dirt sensor and sends signals to the dirt sensor display to show the amount of dirt being picked up by the vacuum.